52 volt Kits and BMS?

Home › Forums › General Discussion › 52 volt Kits and BMS?

Log In Register Lost Password
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 6, 2017 at 11:51 pm #280
    randyCPU
    Participant

    Micah:

    Can you offer a 52 volt kit for eBikes?

    Of course, you will need to source a 52 volt BMS…

    June 23, 2017 at 10:13 pm #283
    besamjohn
    Participant

    I would love to have the same! The 48v is good but 52v would be fantastic.

    September 24, 2017 at 10:07 pm #292
    Steve
    Participant

    Yes, me too. Would like to build a 52V, 14PS6 battery. My frame triangle will not accept currently available packs, but does have enough room for the right dimensioned pack…
    Would also like to have more information on the cells used in the triagular or linear-3 pre spot-welded packs. Is it possible to get them with various cells (ie, 20R, 30Q)?

    Finally, I watched the video of Micah assembling a battery pack out of the triangular 3-cell packs. Since we are soldering the connections between packs, is it still necessary to use nickel strips? Would a single copper wire of appropriate ampacity also suffice? Seems that would be easier than soldering multiple nickel strips…just asking.

  • Author
    Posts
Log In Register Lost Password
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.